PE Butt Fusion Parameter Tools

PE Butt Fusion Parameter Tools

WELPING FIELD PARAMETER TOOLS

PE Butt Fusion Parameter Tools

Select the standard required by the approved project welding procedure. The DVS and ISO calculators are independent tools and their pressure or timing values must not be interchanged.

WELPING operator setting up a PE pipe butt fusion machine in the workshop
WELPING operator setting up a PE pipe butt fusion machine in the workshop
WELPING technician operating a large-diameter PE pipe butt fusion machine
WELPING technician operating a large-diameter PE pipe butt fusion machine
WELPING team commissioning PE pipe butt fusion equipment in the factory
WELPING team commissioning PE pipe butt fusion equipment in the factory
DVS WORKING PARAMETERS

DVS 2207-1:2015-08

  • Interface pressure: 0.15 ± 0.01 N/mm²
  • Heater: 220 ± 10°C
  • Cold, mid, and hot cooling bands
Open DVS calculator
SINGLE LOW-PRESSURE PROCEDURE

ISO 21307:2017

  • Interfacial pressure: 0.17 ± 0.02 MPa
  • Heater: 225 ± 10°C
  • Cooling under pressure referenced to 23 ± 2°C
Open ISO calculator

Use the project-specified standard

These are field calculation aids, not official reproductions of either standard. Confirm pipe material, machine, measured wall thickness, drag pressure, ambient conditions, and the approved WPS before use.